Table of Contents
Advertisement
HTC 270 EG
Tip!
After a change in the grinding head's position (right/left/straight forwards)
during grinding (according to section Setting the grinding head position, page
24
above), the grinding head must be checked to make sure it is horizontal.
Follow steps 4 to 7 in the instruction above to check, and where necessary,
make adjustments so the grinding head is horizontal.
4.10
Transportation
During transport, the machine must be secured for transport with one or more crossed
straps. To prevent damage to chassis parts, a spacing block must always be placed under
the grinding head during transport, see Figure 4-13, page 29.
Figure 4-13. Securing the machine for transport
2.0
Usage
29
Advertisement
Table of Contents
