Changing Grinding Tools; Preparations For Dry Grinding - HTC 800 Classic Manual

Usage
4.5.2

Changing grinding tools

1. Remove the grinding tool by giving it a few light taps with a rubber hammer so
the locking mechanism releases,
up out of the guide slot.
Figure 4-5. Removing grinding tools
2. Slide the grinding tool diagonally, from above, down into the appropriate guide
slot on the tool holder,
the guide slot.
3. Lock the grinding tool into the tool holder by giving it a few light taps with a
rubber hammer - see
4.6

Preparations for dry grinding

Warning!
Check that the splash guard is fitted.
16
see Figure 4-5, page
see Figure 4-3, page
Figure 4-4, page 15.
HTC 800 Classic
16. Then draw the tool
15. Then push the tool fully into
1.0