HTC 270 EG Manual page 36

Usage
5. Loosen the levers 1 and 2 in Figure 4-12,
turned. Turn the adjustment wheel until level B (for right position) or level A (for
left position) is levelled.
Figure 4-12. Adjustment of grinding head in level 2 (shows the grinding head in left position)
6. When the adjustment is completed, first tighten lever 1 and then lever 2 in
Figure 4-12, page 28.
7. If necessary, readjust more exactly according to point 4 above.
Tip!
During grinding, the tools are worn and used up, which affects the grinding
head and the tool's angle to the floor. For this reason, to prevent a change in
angle that can degrade the result of the grinding, the wear on the tool must be
compensated for during the course of the work, by making adjustments using
the adjustment wheel in Figure 4-11, page 27.
Tip!
After changing to new or other grinding tools, the grinding head must be
checked to make sure it is horizontal. Follow steps 3 to 7 in the instruction
above to check, and where necessary, make adjustments so the grinding head is
horizontal.
28
page 28 so the grinding head can be
HTC 270 EG
2.0