Table of Contents
Advertisement
Operation
4.5.2
Changing grinding tools
1.
Remove the grinding tool by giving it a few light taps with a rubber hammer so the
locking mechanism releases, see Figure 4-11, page 20. Then draw the tool up out
of the guide slot.
Figure 4-11. Removing grinding tools
2.
Slide the grinding tool diagonally, from above, down into the appropriate guide slot
on the tool holder, see Figure 4-9, page 19. Then push the tool fully into the guide
slot.
3.
Lock the grinding tool into the tool holder by giving it a few light taps with a rubber
hammer - see Figure 4-10, page 19.
20
HTC 650 HDX
3.0
Advertisement
Table of Contents
