Table of Contents
Advertisement
HTC 650 E Classic
4.5.2
Changing grinding tools
1.
Remove the grinding tool by giving it a few light taps with a rubber hammer so the
locking mechanism releases, see Figure 4-5, page 17. Then draw the tool up out
of the guide slot.
Figure 4-5. Removing grinding tools
2.
Slide the grinding tool diagonally, from above, down into the appropriate guide slot
on the tool holder, see Figure 4-3, page 16. Then push the tool fully into the guide
slot.
3.
Lock the grinding tool into the tool holder by giving it a few light taps with a rubber
hammer - see Figure 4-4, page 16.
3.0
Operation
17
Advertisement
Table of Contents
