Verifying The Configuration - Cisco ASR 5000 Administration Manual

▀ Rel. 7 Gx Interface
 Optional: To configure signalling restrictions, in the IMS Authorization Service Configuration Mode, enter the
following commands:
signaling-flag { deny | permit }
signaling-flow permit server-address <ip_address> [ server-port { <port_number> |
range <start_number> to <end_number> } ] [ description <string> ]
 Optional: To configure action on packets that do not match any policy gates in the general purpose PDP context,
in the IMS Authorization Service Configuration Mode, enter the following command:
traffic-policy general-pdp-context no-matching-gates direction { downlink | uplink
} { forward | discard }
 To configure the PCRF host destinations configured in the GGSN/PCEF, use the
commands.
 To configure the GGSN/PCEF to use a pre-defined rule when the Gx fails, set the
request-type
further interaction with the PCRF.
 For provisioning of default charging method, use the following configurations. For this, the AVPs Online and
Offline will be sent in CCR-I message based on the configuration.
 To send Enable Online:
 To send Enable Offline:

Verifying the Configuration

To verify the IMS Authorization service configuration:
Step 1 Change to the context where you enabled IMS Authorization service by entering the following command:
context <context_name>
Step 2 Verify the IMS Authorization service's configurations by entering the following command:
show ims-authorization service name <imsa_service_name>
▄ Cisco ASR 5000 IP Services Gateway Administration Guide
74
CLI to . Policies available/in use will continue to be used and there will be no
continue
configure
active-charging service <ecs_service_name>
charging-action <charging_action_name>
cca charging credit
exit
configure
active-charging service <ecs_service_name>
rulebase <rulebase_name>
billing-records rf
exit
Gx Interface Support
diameter host-select
failure-handling cc-
OL-27210-02
CLI