Configuring The Ipsg - Cisco ASR 5000 Administration Manual

IP Services Gateway Configuration

Configuring the IPSG

This section describes how to configure the IPSG to accept RADIUS accounting requests (start messages) in order to
extract user information used to apply other services. The following figure illustrates the required components within
the system supporting IPSG.
Figure 6.
To configure the system to perform as an IPSG:
Step 1
Set initial configuration parameters such as activating processing cards and modifying the local context by referring to
procedures in the System Administration Guide.
Step 2
Configure the global active charging parameters as described in the Enhanced Charging Service Administration Guide.
Step 3
Configure the system to perform as an IPSG by applying the example configurations presented in the
Service Configuration
Step 4 Configure the Service Provider context by applying the example configuration presented in the
Configuration section.
Step 5
Bind interfaces to ports as described in the System Administration Guide.
Step 6
Save your configuration to flash memory, an external memory device, and/or a network location using the Exec mode
command
save configuration
System Administration Guide and the Command Line Interface Reference.
Important:
the extent that the most common or likely commands and/or keyword options are presented. In many cases,
other optional commands and/or keyword options are available. Refer to the Command Line Interface
Reference for complete information regarding all commands.
OL-27210-02
IPSG Configuration Detail
section.
. For additional information on how to verify and save configuration files, refer to the
Commands used in the configuration examples in this section provide base functionality to
Cisco ASR 5000 IP Services Gateway Administration Guide ▄
Configuring the IPSG ▀
IPSG Context and
ISP Context
23