Cisco ASR 5000 Administration Manual page 121

Gy Interface Support
The Diameter server can provide with the triggers for which the client should reauthorize a particular category. The
triggers can be configured locally as well but whatever trigger is present in the CCA from the server will have
precedence.
Important:
The trigger types that are supported are:
 SGSN/Serving-Node Change
 QoS Change - Any
 RAT Change
 LAC Change
 CellID Change
On any event as described in the Trigger type happens, the client reauthorizes quota with the server. The reporting
reason is set as RATING_CONDITION_CHANGE.
Tariff Time Change
The tariff change mechanism applies to each category instance active at the time of the tariff change whenever the
server indicated it should apply for this category.
The concept of dual coupon is supported. Here the server grants two quotas, which is accompanied by a Tariff-Time-
Change, in this case the first granted service unit is used until the tariff change time, once the tariff change time is
reached the usage is reported up to the point and any additional usage is not accumulated, and then the second granted
service unit is used.
If the server expects a tariff change to occur within the validity time of the quota it is granting, then it includes the
Tariff-Time-Change AVP in the CCA. The DCCA report usage, which straddles the change time by sending two
instances of the Used-Service-Unit AVP, one with Tariff-Change-Usage set to UNIT_BEFORE_TARIFF_CHANGE,
and one with Tariff-Change-Usage set to UNIT_AFTER_TARIFF_CHANGE, and this independently of the type of
units used by application. Both Volume and Time quota are reported in this way.
The Tariff time change functionality can as well be done using Validity-Time AVP, where in the Validity-Time is set to
Tariff Time change and the client will reauthorize and get quota at Validity-Time expiry. This will trigger a lot of
reauthorize request to the server at a particular time and hence is not advised.
Tariff-Time-Usage AVP along with the Tariff-Time-Change AVP in the answer message to the client indicates that the
quotas defined in Multiple-Services-Credit-Control are to be used before or after the Tariff Time change. Two separate
quotas are allocated one for before Tariff-Time-Change and one for after Tariff-Time-Change. This gives the flexibility
to the operators to allocate different quotas to the users for different periods of time. In this case, the DCCA should not
send the Before-Usage and After-Usage counts in the update messages to the server. When Tariff-Time-Change AVP is
present without Tariff-Time-Usage AVP in the answer message, then the quota is used as in single quota mechanism
and the client has to send before usage and after usage quotas in the updates to the server.
Important:
Final Unit Indication
The Final-Unit-Indication AVP can be present in the CCA from the server to indicate that the given quota is the final
quota from the server and the corresponding action as specified in the AVP needs to be taken.
OL-27210-02
In this release, Gy triggers are not supported for HA.
In this release, Gy does not support UNIT_INDETERMINATE value.
Cisco ASR 5000 IP Services Gateway Administration Guide ▄
Features and Terminology ▀
121