Table of Contents
Advertisement
NS 4000 Configuration
– In the
in the conditions of the selected loading option for the “Full Ahead” main
engine operating mode:
12. Switch to “Tracks” page:
– In the
data (see N
D
ESCRIPTION
– In the
recording the targets’ information (identifiers, coordinates and motion
parameters) (see N
F
UNCTIONAL
13. Switch to the “NMEA Custom” page. For setting up of the reception of
customised NMEA-like sentences for the CONNING task see
Adjustment of NS 4000 ECDIS MFD Operation with NMEA Custom
80
NAVI-SAILOR 4000/4100 ECDIS (v. 2.00.009). Installation Guide
Turn parameters
group, set the ship turning circle parameters
End Speed (rudder 15)
– steady turn speed at 15º rudder angle;
End Speed (rudder 35)
– steady turn speed at 35º rudder angle;
Turn Radius (rudder 15)
– turn radius at 15º rudder angle;
Turn Radius (rudder 35)
– turn radius at 35º rudder angle.
Track of own ship
group, set the time interval for recording the following
-S
4000/4100 ECDIS (
AVI
AILOR
Chapter 6
,
, sections
Primary Position & General Nav. Data
parameters (HDG/STW/COG/SOG): 10 sec only;
Secondary Position
– for own ship secondary position: 10 sec only;
Route Monitoring Data
– for the monitored route name, monitored WPT,
XTD, WPT selection mode: 10 or 20 sec;
Depth
– for depth from echosounder: 10 or 20 sec;
Wind
– for wind: 10, 20, 30, or 60 sec;
Temperature
– for temperature: 20, 30, or 60 sec.
Tracks of Targets
group, set the time interval (10, 20, or 60 sec) for
-S
AVI
AILOR
D
,
ESCRIPTION
. 2.00.009). F
V
General
Own Ship Track
and
– for own ship position and its motion
4000/4100 ECDIS (
Chapter 6
General
, sections
UNCTIONAL
):
. 2.00.009).
V
Target Data
and
).
Annex B
, section
.
Advertisement
Table of Contents
