Table of Contents
Advertisement
Workstations Installation
Dongle Installation
After the computer has been mounted securely in its place, connect the dongle
to the computer’s printer port, as marked “DONGLE” (see picture below).
The dongle should be connected to the printer port of a personal or industrial
computer before the software installation.
The NS 4000 ECDIS MFD System will not operate unless the dongle is connected to
the computer. Description of the dongle is presented in
RS6 Computer
The basic component of Workstation is the RS6 Computer.
Specification of RS6 Computer is presented in
Layout of RS6 Computer connectors for Workstation is described in drawings
“RS6 Computer. Connectors layout” enclosed in
Transas ES6 Dedicated Keyboard with Trackball Installation
Specification of ES6 keyboard with trackball is presented in
document.
For connection ES6 keyboard with trackball to RS6 computer see diagrams
enclosed in
ES6 Keyboard Configuration Switch
ES6 keyboard connected to computer can work in following master modes: ES6 or
ES3. For position of the Configuration switch and connections to the RS6 computer
in the different master modes see table below:
Table 1. ES6 keyboard master modes
Master modes
ES6 keyboard
ES3 keyboard
Configuration switch settings 1–7 designates CAN network node addresses when
keyboard is used as an ES6 slave (secondary) keyboard.
12
NAVI-SAILOR 4000/4100 ECDIS (v. 2.00.009). Installation Guide
Fig. 1. RS6 LPT port for the dongle
Annex G
of this document.
Configuration switch position
8
0
Chapter 3
of this document.
Chapter 3
of this document.
Annex G
of this document.
Chapter 3
Connection to the computer
USB
PS/2 keyboard
PS/2 mouse
Com port RS232
of this
Advertisement
Table of Contents
