Table of Contents
Advertisement
Configuring the PIX-501-BUN-K9
Configuring the PIX-501-BUN-K9 Using PDM Version 3.(0)2
The PIX-501-BUN-K9 contains an integrated configuration utility called Cisco PIX
Device Manager (PDM). PDM is a web browser-based configuration tool designed
to help you set up, configure, and monitor the PIX Firewall. PDM is preinstalled on
the PIX-501-BUN-K9. To access PDM, make sure that JavaScript and Java software
are enabled in your web browser. Use Native (built-in) JVM (VM 3809) or Java
Plug-in 1.4.2. You can download the latest Java Plug-in from Sun Microsystems
(www.java.sun.com). For best performance, use Microsoft Internet Explorer 6.0.
The following requirements are set for a PC which will be used for configuring:
•
SOFTWARE. PDM is not supported on Macintosh, Windows 3.1, Windows 95,
Windows 98, Windows ME, Windows NT operating systems;
•
Hardware Requirements for Windows platforms using PDM 3.0:
– Processor: Pentium III or equivalent running at 450 MHz or higher;
– Random Access Memory: 256 MB;
– Display Resolution and Colors: 1024x768 pixels and 256 colors;
– Minimum of at least 4 MB of temporary disk space to load into the browser.
HTTP 1.1 – Settings for
for both proxy and non-proxy connections.
Use Ethernet cable to connect the configuring PC to one of the four switched inside
ports on the rear panel of the PIX Firewall.
Check the LINK LED to verify that configuring PC has basic connectivity to
the PIX Firewall on one of the inside ports (1 through 4). When connectivity occurs,
the LINK LED on the front panel of the PIX Firewall lights up solid green.
Follow these steps to configure the PIX-501-BUN-K9:
1. Run to S
Double-click the “Network and Dial-up Connections” icon:
222
NAVI-SAILOR 4000/4100 ECDIS (v. 2.00.009). Installation Guide
Internet Option\Advanced\HTTP 1.1 settings
\S
\C
P
TART
ETTINGS
ONTROL
ANEL
.
should use HTTP 1.1
Advertisement
Table of Contents
