Ns 4000/4100 Settings - Transas NAVI-SAILOR 4100 ECDIS Installation Manual

NS 4000 Configuration
Specify the WAGO Module contact by closing/unclosing of which the specified
alarm will be triggered off in NS 4000.
– In the column
acknowledge mode:
Specify the WAGO Module contact by closing/unclosing of which the specified
alarm will be acknowledged in NS 4000 from the outer source.
– In the column
Specify the WAGO Module contact by closing/unclosing of which the specified
alarm will be silenced in NS 4000 from the outer source.
– In the column
alarm acknowledge from the NS 4000:
Specify the WAGO Module contact by closing/unclosing of which the specified
outer source alarm will be acknowledged from the NS 4000.
– In the column
silencing from the NS 4000:
Specify the WAGO Module contact by closing/unclosing of which the specified
outer source alarm will be silenced from the NS 4000.
In much the same way, make settings in the
alarms and warnings via RS6 input/output contacts.

NS 4000/4100 Settings

1. Press
parameters (in the case of NS 4000 network configuration). This page is intended
for specifying the ECDIS task priority on each NS 4000 Workstation. The priority
can only be set for a WS with the Backup role. The highest priority (“0”) has
a Workstation engaged in primary navigation data processing. The function
of navigation data processing is transferred to the Workstations with the lower
priority in a queue (“1”, “2”, etc.) in the case of ECDIS task failure on the Workstation
with “0” priority.
If the Slave role is set for a workstation, it can never be used as the ECDIS
MASTER.
70 NAVI-SAILOR 4000/4100 ECDIS (v. 2.00.009). Installation Guide
Alarm Acknowledge In
N/C – normal closed;
N/O – normal opened.
Alarm Sound In
N/C – normal closed;
N/O – normal opened.
Alarm Acknowledge Out
N/C – normal closed;
N/O – normal opened.
Alarm Sound Out
N/C – normal closed;
N/O – normal opened.
INS
button. Open “Network settings” page to set the NS 4000 network
Contact, specify the outer source alarm
Contact, specify the outer source alarm silencing mode:
Contact, specify the mode of outer source
Contact, specify the mode of outer source alarm
RS6 I/O settings group for work with