Table of Contents
Advertisement
NS 4000 Configuration
– Check for the relevant port of this sensor:
Note: The above mentioned checking can be carried out only on the Workstation,
which COM-port the sensor is connected to:
– Press
– If incorrect data is received, or there is no data, change the COM port
parameters in
60
NAVI-SAILOR 4000/4100 ECDIS (v. 2.00.009). Installation Guide
If COM-port was selected, specify in the drop-down list the following
COM port exchange parameters, defined in technical description of
connected sensor: Baud rate, Bits, Parity, and Stopbits;
To check the propriety of sensor connection, press the button
Port
test.
in the column
Start Monitoring
button.
Port Settings
group. COM port parameters:
Baud
Rate: 50–115200 (by default – 4800);
Data
Bits: 7,8 (by default – 8);
Parity: None, Event, Odd, Space, Mark (by default – None);
Stop
Bits: 1,2 (by default – 1).
Test
Advertisement
Table of Contents
