Table of Contents
Advertisement
Max XTD
– maximum distance from the leg of the monitored route
expected to be used in Track Control mode. It is set within the range
of 1.0 to 5.0 mile;
Initial HDG-Track
monitored route leg for steering to this leg with Track Control mode ON.
It is set within the range of 20 to 60 degrees;
Max course deviation
course from the leg of the monitored route as it is proceeded along in
Track Control mode. It is set within the range of 5 to 30 degrees;
Set the turn arc radius to be used by default when Quick Track mode is
turned on
11. Switch to “Speed Maneuvring” page. This page is intended for configuration Trial
Manoeuvre functionality:
– In the
Ship Loading
– In the
Max. Speed
loading option for the following main engine operating modes (from the Pilot Card):
On Full
Ahead;
On Half
Ahead;
On Slow
Ahead;
On Dead Slow
Stopping\acceleration
– In the
in the conditions of the selected loading option for the following modes
(from Pilot Card):
STOP to FULL AHEAD
to the maximum speed (“Full Ahead” main engine operating mode);
FULL AHEAD to FULL ASTERN
engine operating mode) to 0 (“Full Astern” main engine operating mode);
FULL AHEAD to STOP
operating mode) to 0 (“Stop” main engine operating mode).
– maximum deviation of the current ship course from the
– maximum possible deviation of the current ship
(Default
radius), not less than 0.1 mile.
drop-down list, select the ship loading option;
group, set the ship speed in the conditions of the selected ship
Ahead.
group, set the ship acceleration (stopping) time
– from 0 (“Stop” engine operating mode)
– maximum speed (“Full Ahead” main
– maximum speed (“Full Ahead” main engine
NS 4000 Configuration
Chapter 2. System Settings
79
Advertisement
Table of Contents
