Transas NAVI-SAILOR 4100 ECDIS Installation Manual page 69

– Use UAIS Model group to select the model of the transponder:
AIS (IEC)
Press
with IEC 61993-2;
Press SAAB R4
as an MKD.
– Use DR Settings group to set configuration of AIS targets DR mode:
Check Use DR for AIS Targets
DR mode (recommended);
Minimal SOG to Activate
In
whereby their positions will be reckoned (recommended SOG – 2 kn).
– Use Miscellaneous
Maximum Range
In
within which the AIS targets will be displayed;
Always activated
Check
(see also document N
F
UNCTIONAL
AIS Transponder Interface
– Use the Bogus targets settings
(for NS 4100 installation only when working with the AIS SAAB R4):
From the Read Port
which the BOGUS_OUT port in the NS 4100 is connected to (see item 3);
R4 Admin password
In
password (see document O
T
RANSPONDER
– Use Rhotheta RT-202 settings
N -S 4000/4100 ECDIS (
AVI AILOR
Chapter 1
, section
In Angle Correction
direction of RDF Rhotheta RT-202 bearing origin and the ship’s
centreline plane;
Set the necessary correction polarity
the appropriate radio button.
Note: The correction should be within 180 degrees with a positive (0–179º clockwise) or
negative (0–179º counter-clockwise) relative to the own ship centreline plane.
MOB Alert Alarm
Check
reception of bearing from Rhotheta RT-202 or AIS targets (see also
document N
A
DDITIONAL
RDF Rhotheta RT-202
detailed in the relevant paragraph of
of NS 4000 ECDIS MFD Operation with WAGO Modules
Seetrac Tracking
– Use
Channel Mode or Address Mode, by pressing the appropriate radio button.
radio button to operate with any transponder complying
radio button to operate with SAAB R4 transponder
checkbox to turn on the AIS targets
input box, enter the AIS targets minimum speed
group to set AIS targets display mode:
input box, enter the radius (up to 64 nm) of an area
checkbox for activation displayed AIS targets
-S 4000/4100 ECDIS (
AVI AILOR
D
Chapter 8
,
ESCRIPTION
).
group to set bogus functionality parameters
drop-down list select the SAAB R4 transponder port
input box enter SAAB R4 administrator transponder
PERATOR
S
).
YSTEM
group for RDF settings (see also document
. 2.00.009). A
V
MOB Mode with Use of RDF Rhotheta RT-202
input box, enter an exact correction between the initial
checkbox to turn on the NS 4000 alarm upon
-S 4000/4100 ECDIS (
AVI AILOR
F
Chapter 1
,
UNCTIONS
). Connection of the external MOB button is
group to specify the necessary Seetrac tracking mode:
. 2.00.009).
V
AIS
, section , paragraph
' M R4 AIS C
S ANUAL
F
DDITIONAL
Positive Negative
or by pressing
. 2.00.009).
V
MOB Mode with Use of
, section
Annex B Adjustment
in the
Chapter 2. System Settings
NS 4000 Configuration
A
LASS
,
UNCTIONS
):
section.
67