Ikco DONG FENG S30 2016 Owner's Manual page 83

LIGHT COMBINATION SWITCH
1
Lamp switch (ring A)
Making all lamps off
Rotate the ring A
Making the position lamp or
instrument panel lighting on
Continuously rotate the ring A
Making the low beam/
high beam on
Pull the light combination switch handle
in the direction of driver to switch to the
low beam or high beam.
82
Fog lamp switch (ring B)*
Making front/rear fog lamp
off
Rotate the ring B
Making the front fog lamp
on
Only when the position lamp, high beam
or low beam is lighted can the front fog
lamp comes to work.
Continuously rotate the ring B
Making the front/rear
fog lamps on
When turning off the position lamp, the
ring B for front/rear fog lamp will rotate
along with it, automatically disconnecting
the rear fog lamp and returning to the
front fog lamp position.
Note:
The fog lamp is used in foggy,
rainy or snowy days only.
Lamp non-turned off alarm
If the lamp is not turned off and the
ignition switch is disconnected, the
alarm will sound for 30s; when the lamp
is turned off or the ignition switch is
turned on, the alarm will stop working.
Delay lighting
("follow-me-home"
function)
If the position switch is turned on once,
shut down the engine, rotate the turn
signal lamp switch to right turn and then
reset it, and lock the door; afterwards, all
turn signal lamps will be lighted for about
15 s to facilitate you leave the parking
lot. The delay lighting will be turned off
by pressing down the locking key on the
remote controller or go out automatically
at the end of the delay.