Safety Belt Maintenance - Ikco DONG FENG S30 2016 Owner's Manual

Maintenance of safety belt
If the safety belt has suffered excessively
large impact load, replace the safety belt
and check the anchorage.
During braking, the safety belt may
suffer sudden tension, and the retractor
locking mechanism should have the
safety belt locked at this moment.
If the retractor or safety belt cannot
be locked in the above-mentioned
cases, replace the safety belt assembly
mandatorily.
When the safety belt is required to be
cleaned, pull it out fully and wash it
with the warm water containing a few of
soap, and then have it retracted into the
retractor after being dried completely. It
is not allowed to carry moisture into the
retractor.
Inspection of safety belt
Always ensure that the safety belt,
buckle, latch plate, retractor
anchorage work normally. Check the
safety belt system parts for any other
looseness or damage. If any problem
likely to interfere with the operation of
safety belt is detected, have the belt
serviced either at Dongfeng Franchise
Store
or IKCO authorised representatives
If torn or worn out, the safety belt is
unable to protect your safety any more
during the vehicle collision. The impact
generated during the collision may
totally break the safety belt. Therefore,
please replace the torn or worn safety
belt immediately.

SAFETY BELT MAINTENANCE

and
Warning:
• During the violent collision, the
safety belt, if damaged, even
slightly, should be replaced as a
whole;
• Pay attention to protecting the
safety belt against contamination
from the glazing agent, engine oil,
.
chemicals, especially electrolyte.
It is much safer to clean the safety
belt with the neutral soapy water.
• If the safety belt webbing is worn
out on edges, contaminated or
damaged, replace the whole
safety belt.
• Any servicing and maintenance of
the safety belt shall be done either
by Dongfeng Franchise Store
IKCO authorised representatives
1
or
.
57