Ikco DONG FENG S30 2016 Owner's Manual page 32

Rear seat full-folding
Tilt the rear seat cushion and take off the
rear headrest.
Press the buckle of lower anchorage of
the middle seat belt to detach the latch
plate of belt, and make the belt retracted
fully. Then move the side belt to two
sides. Afterwards, lift up the two pull
buttons on the rear seat backrest and tilt
the backrest backwards, then the rear
seat can be folded.
Note:
It is not allowed to fold the rear seat
before the cushion is tilted, so as to
avoid the detachment of support at the
lower part of backrest.
REAR SEAT (S30)
After folding the rear seat, the cabin
is connected with trunk, enlarging the
space.
Note:
When resetting the rear seat backrest,
always place the side belt at two sides
smoothly, pull out the middle seat belt
and insert the lower latch plate into the
corresponding buckle. After restoring
the backrest to the normal position,
it is a must to check that it has been
locked reliably, or else, the articles in
the trunk may enter into the passenger
compartment and hurt passengers in
case of emergency braking or collision.
1
31