Table of Contents
Advertisement
EN
WEEKLY PROGRAMMES
It is possible to allocate different programs to different days of the week. To do this, the controller has to be upgrade from
24hr mode (factory default) to 24hr/7days mode as follows:
Switch off the panel heater by turning off the main switch at the right side of the heater, the display will be Off. Press the
key and at the same time turn on the main switch maintaining the
which means that weekly mode has been set.
SETTING THE DAY: Press the
number, if required, by pressing
and new values will be stored.
To check a programme or to make a new one press
00:00
display will show
dia1
again
. Repeat this process with the 7 days of the week. When the display shows
by pressing + key.
If the display shows
and so on.
It is possible to allocate any of the three temperature levels to all the intervals of any day maintaining the
relevant
To turn back a controller from 24hr/7days to a single 24hr press
default settings.
KEYBOARD LOCK
Press the
key more than six seconds and the keyboard will be locked. The display will show
will keep on working internally. To unlock the keyboard, press again the
SUN MANUAL OVERRIDE
Maintain the SUN Key pressed for 4 seconds to set the Sun Manual Override. The heater will maintain the sun temperature set
point and will ignore the pre-set program until the next change in programming temperature level.
Both luminous indicators SUN and MOON will be lit. This function could be useful when SUN temperature is required and we
do not want to modify the program.
By pressing the SUN key for 4 seconds with Sun Manual Override activated, the function will be removed and the heater will
follow the programme again.
key more than two seconds and the display will show the number of the day. Set the correct
+
–
or
keys. Press the
intermittently. Follow now the steps from DAILY PROGRAMMES section until the display shows
dia1
then, pressing + key more than three seconds will copy the day 1 program to day 2
key until an audible signal is heard.
key at least five seconds. The display will show
key and the display will show now the time. Press again the
PRG
key: The display will show
PRG
key more than six seconds. This will restore the factory
key more than six seconds.
6
dia1
PRG
. Press again
dia7
the weekly program will be stored
and the controller
P-SE
key
key and the
Hide quick links:
Advertisement
Table of Contents
