PEUGEOT 205 Manual page 173

26.27a Method of releasing the switch
surround upper clips
32 Prise the small tray from the centre
console (see illustration).
33 Remove the screws, and slide the
surround up the gear lever (see illustration).
34 Remove the upper and lower nuts, and
withdraw the centre console
illustrations).
35 Unclip the felt cover from under the facia.
36 Remove the screws and withdraw the
front facia panel. Disconnect the wiring from
the switches (see illustration).
37 Remove the heater control panel retaining
screws.
38 If necessary, remove the side vents.
39 Remove the instrument panel (Chapter 12)
26.31 Prise out the console vent and
remove the screw
26.34a Removing the centre console
upper nuts . . .
26.27b Remove the lower screws and
withdraw the surround
and choke cable, where applicable (Chap-
ter 4A).
40 Remove the left lower facia mounting
screw.
41 Unclip the glovebox and remove the
(see lighting switch. Also remove the light.
42 Remove the remaining mounting screws
and nuts, and withdraw the facia sufficiently
to disconnect the wiring. Access to the front
mounting nuts is gained by removing the
wiper arms and the plastic guard from the
plenum chamber in the engine compartment.
Identify each wire for location.
43 Unclip the fuse and relay panel, and
withdraw the facia panel from the car.
26.32 Removing the centre console tray
26.34b . . . and lower nut
Bodywork and fittings 11•13
26.29 Steering column mounting nuts
(arrowed)
Refitting
All models
44 Refitting is a reversal of removal, but on
completion check the operation of all
electrical components.
26.33 Remove the screws and slide the
surround up the gear lever
26.36 Front facia panel screws (arrowed)
11