Seats - Removal And Refitting; Sunroof - General Information; Grab Handles; Front Seat Rear Inner Mounting Bolts - PEUGEOT 205 Manual

11•10 Bodywork and fittings
7 Unscrew the five bolts securing the
regulator mechanism.
8 Remove the casing from the hood hinge.
9 Remove the pad from the quarter glass
lower channel.
10 Push in the regulator mechanism, then tilt
it and withdraw it through the aperture,
complete with the cable (see illustration).
Take care not to damage the seat belt reel.
11 Remove the inner
weatherstrip and clips.
12 Push the plastic rivet centre pins and
remove the stretcher support.
13 Lift the glass and remove it.
Refitting
14 Refitting is a reversal of removal. If a new
glass is being fitted, position the lower channel
as shown (see illustration). Remove the guide
pads from the old glass by drilling out the rivet
heads. Fit them to the new glass using the
special sleeves and screws obtainable from a
Peugeot dealer (see illustration). Apply a little
locking fluid to the screw threads before
inserting and tightening them. Unlike the door
glass, there are no adjustment points.

21 Seats - removal and refitting

Removal
Front seat
1 Move the seat fully forward and remove the
rear inner mounting bolts (see illustration).
2 Remove the remaining mounting bolts from
under the car and from the brackets, then
remove the seat from the car.
Rear seat
3 Fold the cushion forwards and unbolt it
from the hinges (see illustration).
4 Fold the backrest down, unscrew the nuts
from the outer pivot bracket(s) and withdraw
the backrest from the inner pivot (where
applicable).
Refitting
5 Refitting the front and rear seats is a
reversal of removal.
22 Grab handles - removal and
refitting
Removal
1 Prise up the cover plates for access to the
screws at each end.
2 Remove the screws and the grab handles.
Refitting
3 Refitting is a reversal of removal.
quarter glass
20.10 Removing the rear quarterlight glass regulator mechanism on Cabriolet models
2
20.14a Channel position on the rear
quarterlight glass - Cabriolet models
x = 145.0 mm

23 Sunroof - general information

The sunroof fitted to some models
incorporates an outer glass and inner cover.
The control handle operates lock latches
located at the rear of the sunroof. The handle
also operates a vacuum seal system which
1

21.1 Front seat rear inner mounting bolts

20.14b Screw (a) and sleeve (b) for fitting
the guide pads to the rear quarterlight
1 Guide pads
holds and seals the sunroof in any desired
position.
The vacuum seal is operated by engine
vacuum. With the handle shut, the vacuum
valve is closed and the seal exerts pressure
under the periphery of the glass. When the
handle is opened, the vacuum valve opens
and causes the seal to collapse, enabling the
glass to be moved.
glass on Cabriolet models
21.3 Rear seat cushion hinge