Facia Front Mounting Nut; Removing A Right-Hand Lower Facia Panel Securing Screw - PEUGEOT 205 Manual

11•12 Bodywork and fittings

26.13 Facia front mounting nut

13 With the bonnet open, remove the plastic
grille and unscrew the front facia mounting
nuts (see illustration).
14 Withdraw the facia panel at the same time
disconnecting the relevant switches and cigar
lighter. Reconnect the
immediately to ensure correct refitting.
1988 models onward
15 Disconnect the battery negative lead.
16 Remove the screws and withdraw the
right-hand lower facia panel (see illustration).
17 Prise out the instrument panel rheostat,
and disconnect the wires.
18 Remove the screws and withdraw the
lower steering column shroud.
26.19b . . . and triangular cover
26.22b . . . and lower screws
26.16 Removing a right-hand lower facia
19 Prise out the coin box and the triangular
cover (see illustrations).
20 Pull off the heater control knobs.
21 Remove the screws in the outer control
knob apertures and withdraw the heater
switch wiring
control surround (see illustration).
22 Remove the screws and withdraw the
central vent assembly (see illustrations).
23 Remove the radio (Chapter 12) or
oddments compartment, as applicable.
24 Remove the screws and withdraw the trim
quadrants from each side of the facia.
25 Remove the ashtray and disconnect the
wiring from the cigar lighter (see illustration).
Identify the wiring.
26.21 . . . Withdraw the heater control
26.25 Removing the ashtray
panel securing screw
surround
26.19a Prise out the coin box . . .
26 Unclip the clock
illustration).
27 Insert lengths of welding rod, or similar,
into the holes at the top of the switch
surround to release the upper clips, then undo
the lower screws and remove the surround
(see illustrations).
28 Prise the steering column grommet from
the floorpan.
29 Unscrew the mounting nuts and lower the
steering column to the floor (see illustration).
30 Prise the small vents from each side of the
centre console.
31 Pull back the carpet and remove the
screws (see illustration).
26.22a Removing the central vent
assembly upper . . .
26.26 Removing the clock surround
surround (see