Bulbs (Interior Lights); Number Plate Light; Reversing Light (1991 Models Onward); Map Reading Light - PEUGEOT 205 Manual

8.19 Removing a rear light cluster bulb
8.22 Remove the rear number plate light
lens . . .
21 Depress and twist the bulb to remove it
(see illustration).

Number plate light

22 Twist off the lens (see illustration).
9.3 Prise out the interior light for access to
the bulb
9.5 Removing the map reading light and
extract the bulb
8.20 Remove the rear foglight lens . . .
8.23 . . . and extract the bulb
23 Depress and twist the bulb to remove it
(see illustration).

Reversing light (1991 models onward)

24 On later models, a single reversing light is
mounted in the rear valance, instead of the
twin lights in the rear light clusters fitted to
previous models.
25 Bulb renewal is as described previously
for the rear foglight bulb.

9 Bulbs (interior lights) -

renewal
General
1 See Section 8, paragraphs 1 and 3.
2 Some switch illumination/pilot bulbs are
integral with their switches and cannot be
renewed separately.
9.7 Removing square type instrument
panel bulbholder
Body electrical system 12•11
8.21 . . . and extract the bulb
Bulb renewal
Interior light
3 Prise the light from the console (see
illustration).
4 Extract the festoon type bulb from within
the light unit.

Map reading light

5 Prise the light from the console and extract
the festoon type bulb (see illustration).
Instrument panel bulbs
6 Remove the instrument panel, as described
in Section 5.
7 Two types of bulb are fitted. Pull out the
square type bulbholder and remove the
wedge type bulb (see illustration). Twist the
round type bulbholder through 90° to remove
it, but on this type the bulb cannot be
separated from the holder.
Glovebox light
8 On pre-1988 models, remove the switch,
with reference to Section 4, then depress and
twist the bulb to remove it.
1
9 On 1988 models onward, open the
glovebox and prise out the light. Remove the
festoon-type bulb from the terminals.
Clock illumination bulb
10 Remove the clock as described in Sec-
tion 6.
11 Twist the bulbholder from the rear of the
clock, then remove the bulb from the holder
(see illustration).
9.11 Removing digital clock illumination
light bulb
12