Inserting/Removing A Cd - Roland CD-2 Owner's Manual

Getting Started

Inserting/Removing a CD

Inserting a Disc
1
Press .
The disc tray opens.
2
Place the disc on the disc tray.
3
Press once again.
The disc tray closes.
• You can also close the disc tray by gently pressing
the front of the disc tray.
• You can also close the disc tray by pressing
the CD side. When the disc is detected, playback
will begin automatically.
• When the disc has been detected, "CD" is indicated
as the audio source name.
Source name
In the case of a previously recorded disc or a music
CD, the total number of songs and the total
playback time will be displayed when this
information has been read from the disc.
Total number of tracks
26
Place with the label surface
facing upward
Disc tray
on
Total playback time
Removing a Disc
1
Press .
The disc tray opens.
2
Remove the disc.
3
Press once again.
The disc tray closes.
• You can also close the disc tray by gently pressing
the front of the disc tray.
If the Disc Tray Doesn't Open
If pressing [EJECT ( )] fails to open the disc tray, you can
forcibly open the tray by pushing a straightened paper clip
into the emergency eject hole.
NOTE
• Never use the emergency eject hole to open the disc
tray while the CD-2 is operating.
1
Switch off the CD-2's power.
Page 24, "Turning the Power Off"
2
Push a straightened paper clip (or similar
object) into the emergency eject hole.
Emergency eject hole
The disc tray is ejected forcibly.
Pull out the disc tray, and remove the disc.
3
Push the disc tray closed.