Inserting/Removing A Memory Card - Roland SP-404 Owner's Manual

Inserting/Removing a
Memory Card
The power of the SP-404 must be turned off when you insert or
remove a memory card. If you insert or remove a memory card
while the power is on, you risk damaging the data of the
memory card or rendering it unusable.
Inserting a Memory Card
1.
Insert the memory card into the card slot located on the
front panel.
Carefully insert the memory card all the way in—until it is
firmly in place.
If a memory card is being used for the first time, you'll have to
format it on the SP-404. (p. 38)
Memory cards that were formatted on another device will not
be recognized by the SP-404.
Removing a Memory Card
1.
Press the eject button located beside the front panel card
slot. The memory card pops out partway. Grasp the
memory card and pull it all the way out.
Preventing Theft of the Memory
Card
When the SP-404 is shipped from the factory, a special screw is
installed in the location marked ★ on the bottom of the unit.
With the memory card cover attached, you can use a Phillips
screwdriver to remove this screw and move it over to the hole
marked "CARD LOCK." Once screwed in there, the memory
card cover cannot be removed. This will help prevent theft of
the memory card.
★
When turning the unit upside-down, get a bunch of
newspapers or magazines, and place them under the four
corners or at both ends to prevent damage to the buttons
and controls. Also, you should try to orient the unit so no
buttons or controls get damaged.
When turning the unit upside-down, handle with care to
avoid dropping it, or allowing it to fall or tip over.
Before You Start
11