Basic Operation; Turning The Power On/Off; Getting Started - Roland CD-2 Owner's Manual

Getting Started

Basic Operation

Turning the Power On/Off

Turning the Power On
NOTE
• Once the connections have been completed (
20), turn on power to your various devices in the order
specified. By turning on devices in the wrong order, you
risk causing malfunction and/or damage to speakers
and other devices.
• This unit is equipped with a protection circuit. A brief
interval (a few seconds) after power up is required
before the unit will operate normally.
If No Other Equipment is Connected to
the CD-2
1
Turn
2
On the rear panel, press
The power turns on. Once the power is on, the screen
lights up.
Turning the Power Off
If No Other Equipment is Connected to
the CD-2
1
Turn
2
On the rear panel, press
The power turns off.
24
Page
counterclockwise to
"MIN" (minimum).
.
counterclockwise to
"MIN" (minimum).
.
If Other Equipment is Connected to the
CD-2
Make sure that the device connected to the
CHECK
AUX OUT jack is powered off.
1
Minimize the volume of all connected
devices.
2
Turn
3
On the rear panel, press
The power turns on. Once the power is on, the screen
lights up.
4
Power up the device connected to the
AUX OUT jack.
If Other Equipment is Connected to the
CD-2
1
Switch off the power on all connected
equipment.
2
Turn
3
On the rear panel, press
The power turns off.
counterclockwise to
"MIN" (minimum).
.
counterclockwise to
"MIN" (minimum).
.