Table of Contents
Advertisement
2.2 I/O Ports
2.2.1 UTC-520FP-IKA0E
A
A. Power Switch
B. Line-Out
C. Mic-In
D. USB for bottom side peripheral module K. LAN 1
E. COM2
F. COM1
G. USB 2.0 x 2
2.3 Setup Procedures
2.3.1 System Power On
1.
For the UTC-520FP-IKA0E models, a 12V/7A power adaptor.
2.
Hold power cords by the plugs ends only. Refer to Section 2.2 for the location of
the DC/AC power input and power switch.
3.
Press the power switch to activate the system. The PWR LED should emit a
green light.
2.3.2 BIOS Setup
For most UTC series, the system setup and configuration will be completed by the
dealer or system integrator prior to delivery. However, users may still need to access
the BIOS setup program to adjust the system configuration, such as the date/ time or
hard drive type. The setup program is stored in read-only memory (ROM) and can be
accessed following system reset or by pressing the "Del" key after powering on the
computer. The settings selected in the setup program are recorded in CMOS RAM
memory, which is backed up by a battery to ensure the settings are retained after the
system is powered off. When booting up, the system compares the settings stored in
CMOS RAM with the POST self test results. If a discrepancy is found, an error mes-
sage is displayed on screen and users are prompted to run the setup program.
UTC-520 User Manual
E
F
B
C
D
8
G
J
K
H
I
H. USB 3.0 x 2
I. HDMI
J. VGA
L. LAN 2
M. DC Input
L
M
Advertisement
Table of Contents
