User - ETC Ion Xe Operating Manual

{String TX IP Address}
Sets the destination IP address or ACN devices supporting the ACN String EPI that the console will
use to send strings. This can contain either an IP address for UDP string destinations or ACN device
names.. A combination of UDP and ACN devices are not supported. Please see
page 523)
{String MSC TX}
When enabled, this setting will cause the console to send serial strings when certain actions happen
at the console. See
Remotes
The {Allow Remotes} button is for allowing Net3 RFR, iRFR, and aRFR connections. The default set-
ting is "Enabled". For more information see
Partitions
Pressing the {Partitions} button in system setup opens the partition display in the CIA. This display
shows any recorded partitions, including the four pre-existing partitions. For more information, see
Using Partitions (on
Users
In this display, you can set the User ID for the console by selecting the {User ID} button and entering
a number from the keypad. You can also add or delete users from this display.
For more information on User ID see
Recall User Settings
When multiple users are in a system, this option allows you to select a user to recall their settings.

User

This setup softkey accesses settings for a specific user. Changing these settings does not impact
other users on the network.
The following buttons are available in User settings:
Record Defaults (below)
Manual Control (on page 161)
User Displays (on page 161)
Record Defaults
Press {Record Defaults to enter this category.
Eight fields will be available to you: {Track}, {Record Confirm}, {Delete Confirm}, {Auto Playback},
{Update Mode}, {Break Nested}, {Update Last Ref}, and {Emergency Mark}.
Note:
Setup
for more specific configuration information.
Sending From User Events (on
page 453).
{Emergency Mark} is not available on Element 2.
page 528).
RFR (on page 490).
About User ID (on page 458).
String Interface (on
159