Assembly - Grizzly G0568 Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble bandsaw:
1. Remove the hex bolts, lock washers, and flat
washers that hold the rail onto the table, then
remove the rail.
2.
Flip the rail over and re-install with the fast-
ners removed in Step 1.
3. Install the fence handle on the fence, if it is
not already installed.
4. Tighten the hex nut on the fence handle
against the fence pivot block (see Figure 24).
Pivot Block
Fence
Handle
Figure 24. Fence handle components.
-24-
Hex Nut
5.
Pull the fence handle up and place the fence
assembly on the rail (see Figure 25).
Figure 25. Example of installing fence onto rail.
6.
Push the fence handle down to lock the fence
assembly in place.
7. Slide the handwheel (see Figure 26) on to
the shaft.
Handwheel
Figure 26. Handwheel correctly installed.
8. Tighten the cap screw in the handwheel
securely.
9. Thread the handle in to the handwheel and
tighten with the 14mm wrench.
Model G0568/G0569 (Mfd. Since 10/11)
Handle