Test Run - Grizzly G0568 Owner's Manual

Test Run

Once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
The test run consists of verifying the following: 1)
The motor powers up and runs correctly, 2) the
safety disabling mechanism on the switch works
correctly, and 3) the stop button safety feature
works correctly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on Page 53.
If you still cannot remedy a problem, contact our
Tech Support at (570) 546-9663 for assistance.
To test run the machine:
1. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is set up properly.
2.
Make sure all tools and objects used during
setup are cleared away from the machine.
3.
Connect the machine to the power source.
4.
Verify that the machine is operating cor-
rectly by turning the switch disabling key (see
Figure 32) to "1" and turning the machine
ON.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
-28-
Figure 32. G0568 switch disabling key and ON/
OFF switch.
5. Press the OFF button to stop the machine.
6.
WITHOUT resetting the OFF button, press
the ON button. The machine should not
start.
—If the machine does not start, the OFF but-
ton safety feature is working correctly.
—If the machine does start (with the stop
button pushed in), immediately disconnect
power to the machine. The OFF button
safety feature is not working correctly. This
safety feature must work properly before
proceeding with regular operations. Call
Tech Support for help.
7.
Push the OFF button in, then twist it clock-
wise so it pops out. When the OFF button
pops out, the switch is reset and ready for
operation (see Figure 33).
OFF Button
Figure 33. Resetting the switch.
Model G0568/G0569 (Mfd. Since 10/11)