Control Settings; Fast Access Keypad; Integrated Digital Remote Control - JEM Glaciator Dynamic User Manual

Control settings

F a s t A c c e s s K e y p a d
On the rear of the machine, fast access keys are provided to rapidly set the
operating mode and parameters of the machine.
The Prime button activates Priming mode.
The large round button activates the low-fog output when the system is in a
Ready state.
The 25-50-100 buttons enable low-fog output at 25%, 50% or 100% output.
The power button switches the unit between STANDBY (On) and OFF operational
modes.
To enter OFF mode, hold the power button down for 5-seconds. Selecting OFF
will disable the heaters and cooling system on the unit engaging the shutdown
procedure of the machine for 160-seconds. During this period the waste
condensate pump will move condensate fluid from the sump in the low-fog outlet
into the waste condensate reservoir. Empty the waste condensate reservoir for
travel and storage. Repeat if necessary until no more fluid is pumped.
The current machine status can always be viewed on the integrated digital
remote control on the left-hand side of the machine.
I n t e g r a t e d D i g i t a l R e m o t e C o n t r o l
The integrated digital remote control on the side of the machine allows you to
configure all settings using option menus.
Empty the waste condensate reservoir prior to engaging the OFF
shutdown procedure. It is possible for the shutdown procedure to
produce condensate that could overfill the reservoir if it is already
near capacity.
The remote control may be removed from the unit and used at a
distance by removing the two handwheel bolts either side of the
display. The included remote cable is 5 m (16.4 ft.) and may be
extended up to a maximum 25 m (82 ft.) using standard 3-pin XLR
cable.
Control settings
12