Ducting; Remote Control Configurations - JEM Glaciator X-stream User Manual

have a maximum output pressure of 3 bar (44 psi). These contacts are
voltage free, and allow the remote pump to be active only when the
machine is fired.
As the contacts are voltage free, they can be connected in parallel with
the signals from other Glaciator X-Streams which share the same fluid
supply. This forms a 'wired or' function, which enables the pump when any
or all machines are operated. The output must not be used to control
mains (line/net) voltages directly.
D U C T I N G
When ducting is fitted to the fixture, locate the DIP switches under the
control panel, and set DIP switch 10 (marked as 'S1') to on. This setting
allows the fan to run on a further six seconds after the fixture has finished
firing. This clears the ducting of any smoke, thereby preventing the build
up of condensation.
R E M O T E C O N T R O L C O N F I G U R A T I O N S
The Heavy Fog Glaciator provides three remote control methods:
PLC interface This connection is an option available to installers who
wish to control the machine using the outputs from a
standard Programable Logic Controller (PLC).
The interface allows 'voltage free' control signals to
switch the Fog, Standby, Timer and Ice functions. The
output levels and timer settings must be made using the
Glaciator X-Stream control panel. This interface is
further described in "PLC interface" on page 19.
JEM remote A JEM remote control can be connected to the Remote
control interface. The remote uses a standard 3-pin XLR
connector. You can control the amount of fog ia the
remote, but the density (fan) level must be set using the
control panel on the Glaciator X-Stream.
Contact your Martin or Jem dealer to order a remote
control.
The pin configuration of the remote connection is:
Pin 1 - Ground
Pin 2 - 12 volt output
Pin 3 - Input
Installation 11