Using The Settings Menu; Setting The Dmx Personality And Start Address; Display Back Light Setting; Master/Slave Link Mode - JEM Glaciator Dynamic User Manual

First set the RUN TIME and OFF TIME values from the menu using the Menu
Previous / Next buttons. The timer values are displayed in the range of 0-250
seconds. Select an interval for the 'On' time; Press Enter to store the value, SET is
displayed. Follow the same procedure for the 'Off' timer.
Next select the Fog output value from the FOG LEVEL menu and press Enter, SET
is displayed.
Finally select the TIMER option from the RUN MODE menu, press ENTER, SET is
displayed. The timer will cycle continuously until the run menu option is
changed.
U s i n g t h e S e t t i n g s m e n u
Options such as the DMX start address, DMX personality setting, display
brightness, stand-alone master/slave linking mode, priming and factory reset are
found in the SETTINGS menu.
Use the Menu Previous / Next buttons to select the SETTINGS option.
Press the Enter button to go to the SETTINGS menu.
To return to the main menu, use the Menu Previous / Next buttons to select EXIT
and press Enter.
S e t t i n g t h e D M X p e r s o n a l i t y a n d s t a r t a d d r e s s
There are two DMX personalities available: 1-channel and 2-channel mode. See
the DMX table on page 17 for more details. The default setting is 1-channel DMX
mode. To change this to the 2-channel mode use the Menu Previous/Next
buttons to select LINK MODE RECEIVE 2C, press Enter, SET is displayed.
To change the DMX start address use the Menu Previous/Next buttons to select
the DMX option from the SETTINGS menu. Use the Up/Down buttons to set the
DMX base address from 001 to 512. If you hold down the button the address will
count up or down more quickly. Press the Enter button to store the address
setting, SET is displayed. (Note that the DMX start address range is limited from
001-511 in 2-channel mode.)
The machine will automatically respond to a DMX controller whenever it is
connected. When using in a DMX system ensure the LINK MODE menu is set to
RECEIVE (the default setting) to avoid causing DMX errors to other devices on
the system.
Alternatively the DMX personality and start address can be set via RDM.
D i s p l a y b a c k l i g h t s e t t i n g
You can set the brightness of the display backlight using the BACK LIGHT option.
Use the Previous / Next buttons to select the BACK LIGHT option from the
SETTINGS menu.
Use the Up/Down buttons to change the option to LOW, NORM or HIGH.
Press the Enter button to store the setting, SET is displayed.
M a s t e r / s l a v e l i n k m o d e
It is possible to control several machines from one digital remote control. The
machine with the remote plugged into it is set as the Master. The other machines
are set as Slaves. The machines are interconnected with DMX cabling.
14
Control settings