Page 2
Normal Conditions Inspect and clean/replace every NOTE! The JEM warranty will be void if any fluid other than JEM 250 hours approved fluid is used. If other fluids are used there could be serious Severe Conditions...
Control Panel Functions Valid start codes = 0 (dimmer data only) Full framing error detection implemented The Timer Analogue control via standard JEM Multifunction Contoller. Optional PLC interface for simple switching control of the system. Basic Operation CONTROL PANEL The Fluid System...
Fan Display Displayed when the Standby switch is set to OFF. dEn/oFF The Heavy Fog Glaciator is the first of a new generation of JEM professional Heavy Fog machines, designed for touring and installation in a variety of dEn/nor Shows the current Density setting.
Do not remove the covers or attempt to repair a faulty machine, an autho- Displayed when the heater is running but the machine is not rized JEM dealer should be contacted in the event of a faulty machine. ready. Fog/Ht...
Continuous operation gives rise to the possibility of pump damage if the machine runs out of fluid. This is overcome in the Heavy Fog Glaciator by using an electronic fluid sensing system, ensuring that the pump is shut down when the fluid level is too low.
REMOTE CONTROL OPTIONS If starting the machine for the first time, or after the fluid has been changed, The Heavy Fog Glaciator provides the user with 3 ways to implement a the pump may need to be primed. remote control on the machine. The main control panel is fixed and can not Do this by setting the Fog output to 15 and firing the machine for 10 be removed for remote operation.
HEAVY FOG GLACIATOR HEAVY FOG GLACIATOR USER USER GUIDE GUIDE DMX OPERATION ICE: Setting this switch to ON, will start the compressor (displays ‘St’ while The machine may be operated using the industry standard DMX 512 digital starting). If the compressor fails to start within 10 seconds, the display will control protocol.
Page 9
HEAVY FOG GLACIATOR HEAVY FOG GLACIATOR USER USER GUIDE GUIDE CONTROL PANEL FUNTIONS The control panel provides a means to enable the various functions that The machine uses a ‘pump ramping’ technique to allow continuous control the Fog and Fan operation. The switches have a maintained action, operation.
THE DISPLAY To store the new value into non-volaile memory, the enter key must be Two LED displays are used in the Heavy Fog Glaciator to show status and pressed before moving on to another menu or leaving the edit mode.