Electrical Connection - Alto-Shaam 100-HW/D4 Installation Operation & Maintenance

e l e c t r I c a l c o n n e c t I o n
1. An identification tag is permanently mounted on
the appliance.
2. This appliance is equipped with a three-prong
grounding plug. For your protection against
shock hazard this appliance should be plugged
directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding
prong from this plug. Plug the appliance into a
properly grounded receptacle ONLY, positioning
the appliance so that the plug is easily accessible
in case of an emergency. Arcing will occur when
connecting or disconnecting the appliance unless
all controls are in the off position.
3. Proper receptacle or outlet configuration or
permanent wiring for this appliance must be
installed by a licensed electrician in accordance
with applicable local electrical codes.
NOTICE: Where local codes and CE regulatory
requirements apply, appliances must be
connected to an electrical circuit that is
protected by an external GFCI outlet.
For CE approved appliances:
electrical shock hazard between the appliance and
other appliances or metal parts in close vicinity,
an equalization-bonding stud is provided. An
equalization bonding lead must be connected to
this stud and the other appliances/metal parts
to provide sufficient protection against potential
difference. The terminal is marked with the
following symbol.
I n s t a l l a t I o n
To prevent an
MN-37234 (Rev. 3) 06/16 • Hot Food Holding Drop-In Well • 24
CAUTION
Power source must match voltage identified
on appliance rating tag. The rating tag
provides essential technical information
required for any appliance installation,
maintenance or repairs. Do not remove,
damage or modify the rating tag.
WARNING
To prevent SERIOUS INJURY, DEATH or
PROPERTY DAMAGE:
All electrical connections must be made
by a qualified and trained service
technician in accordance with applicable
electrical codes.
WARNING
To prevent SERIOUS INJURY, DEATH, or
PROPERTY DAMAGE:
All electrical connections must be
made by a qualified and trained service
technician in accordance with applicable
electrical codes.
This appliance MUST be adequately
grounded in accordance with local
electrical codes or, in the absence of local
codes, with the current edition of the
National Electrical Code ANSI/NFPA No.
70. In Canada, all electrical connections
are to be made in accordance with CSA
C22.1, Canadian Electrical Code Part 1 or
local codes.