Remote Control Mounting Instructions - Alto-Shaam 100-HW/D4 Installation Operation & Maintenance

re Mo te control H oU sIn G Mo U n tInG In s tr U ct Ion s
DECOR FACE SCREWS
Cut an appropriate sized opening in the location where
1.
the control is to be positioned. See chart on page 18 for
cutout size.
2. Thoroughly clean and dry the mounting surface around
the control cut-out opening on which the décor face
will be applied.
NOTICE: The control face will not properly adhere to
an unclean surface.
3. Remove the knob(s) from the thermostat(s) by pulling
knob away from control. Remove the décor face from
the appliance by removing the two (2) screws located
to the right and left of the thermostat.
I n s t a l l a t I o n
MN-37234 (Rev. 3) 06/16 • Hot Food Holding Drop-In Well • 19
"TOP" ETCHING
4. Making sure "TOP" etching is at the top, route control
housing through opening cut in step 1. Secure the
décor face housing to the control housing using the
screws removed in step 3.
5. Remove the protective film from the mounting tape on
the inside flanges of the décor face and apply the décor
face to the mounting surface. Two holes are provided
in décor face for additional mounting screws (not
provided) if desired.
6. Reattach the knob(s) to the thermostat(s).
Apply a food grade silicone
under the edge of the hot
well support flange.