Accurow Setup; Planter Row & Section Setup - Raven Cruizer II Operation Manual

AccuRow Setup

Planter Row & Section Setup
Note: The Sections icon is only displayed in the Tools Menu if an
AccuBoom or AccuRow node is connected to the Cruizer II CANbus.
The Section configuration uses the programmed antenna Fore/Aft
and Left/Right values to determine the relative location of each section
with respect to the GPS antenna. If the antenna position settings are
modified, verify that the section settings are correct before starting or
resuming an application.
1. From the home screen, touch
Tools and select the Sections
icon in the Vehicle menu. The
Rows setup screen will be
displayed.
2. Use the number of rows slider or
touch the keypad icon to the
right to set the number of rows
on the implement (maximum of
48).
3. Use the row spacing slider or
touch the keypad icon to the
right to set the spacing between
the rows.
Note: The currently selected units are displayed below the row spacing slider.
Be sure to enter the measured row spacing in the units displayed.
4. Touch the Green Arrow icon to advance to the Sections setup screen.
Number of
Section Slider
5. Touch the lock icon to the right of the sections slider to unlock the Sections
screen and allow values to be entered or modified.
Note: The keypad icon must be displayed before any values may be entered
or recalibrated.
Center Sections
Settings Lock
6