Accuboom Setup; Sprayer Section Setup - Raven Cruizer II Operation Manual

AccuBoom Setup

Sprayer Section Setup

Note: The Sections icon is only displayed in the Tools Menu if an AccuBoom
or AccuRow node is connected to the Cruizer II CANbus.
The Section configuration uses the programmed antenna Fore/Aft and
Left/Right values to determine the relative location of each section with
respect to the GPS antenna. If the antenna position settings are
modified, verify that the section settings are correct before starting or
resuming an application.
1. From the home screen, touch Tools and select the Sections icon in the
Vehicle menu to display the sections setup screen.
Number of
Section Slider
2. Touch the lock icon to the right of the sections slider to unlock the Sections
screen and allow values to be entered or modified.
Note: The keypad icon must be displayed before any values may be entered
or recalibrated.
3. Use the number of sections slider to set the number of boom sections
(max. of 10) on the implement. Cruizer II automatically divides the
implement width (displayed in the lower, left information area) by the
number of sections entered.
Note: Touch the implement value in the lower, left information area to enter a
different implement width.
4. Below the sections slider, the width and offset of each section is displayed.
Section 1 corresponds to the left most boom section in a standard boom
configuration. Use the up or down arrows if necessary to view the settings
for each section.
Touch the width or offset values to display the on-screen keypad and enter
a new value.
5. If the sections are set end-to-end, centered on the swath midpoint, touch
the Center Sections icon to automatically align and center the boom
sections.
6. Touch the Check Mark to return to the tools screen or touch the Home
Icon to return to the home screen.
3
Center Sections
Settings Lock