Communication Settings And Calibration; Connect The Instrument To The Computer; Connect The Instrument To Win-Situ 5 Software - In-situ Aqua Troll 400 Operator's Manual

Communication Settings and Calibration

Before you program the instrument to work with your PLC/SCADA system, you must set appropriate communication
settings using a TROLL Com, AC/DC converter, and Win-Situ 5 Software. The software can also be used to calibrate
sensors and to restore factory calibration and communication settings.
Always wear appropriate personal protective equipment and use proper laboratory
technique when calibrating the sensors and operating the instrument.

Connect the Instrument to the Computer

Using a direct-connect TROLL Com Communication Device, powered with an AC/DC power supply, you can connect the
Aqua TROLL 400 to a computer running Win-Situ 5 Software version 5.6.22 or later.

Connect the Instrument to Win-Situ 5 Software

Install Win-Situ 5 Software from the Resources CD or from www.in-situ.com. Make sure you select the check box that
installs the USB drivers.
Open Win-Situ 5 Software and click the Connect button
800-446-7488
to connect to the instrument.
15 www.in-situ.com