Closing The Housing - Fronius TransPocket 1500 Service Manual

Fitting the FPA15
board
(continued)
Fig.24
Closing the
housing
Fig.25
(34)
Fig.26
(5) (40) (41)
(21) (37)
(36)
(35)
- Plug the 10-pole Molex plug (41) onto
(42)
board LCA15
- Plug the 2-pole Molex plug (40) onto
board LCA15
- Arrange the ribbon cable (42) above
the cable harness, as shown in Fig.15
- Plug the ribbon cable (42) to board
FPA15 (5)
- Insert the board insulator (37)
- Insert the housing stiffening element
(21)
- Plug the "housing earth conductor" (36)
onto the housing box, in the correct
position
- Replace the housing box
- Screw the 5x25-TX20 screw (35) back
onto the rear of the housing
- Screw the 5x25-TX20 screw (34) back
onto the front of the housing
- Fit the carrying strap back on again
113