Table of Contents
Advertisement
5. Make sure that there is no proximity between the controller unit and factors
with an internal noise source, such as an external power transformer with high
power
Delay symptom (too long-time gap) between a command mission from the controller
and feedback on the end unit
A possible cause of the phenomenon
1. Some units are connected to the controller but are out of range
2. After the initial definition, there were added disturbing units such as a cabinet,
mirror and any other possible factor
3. A unit appears in the list of units as MALFUNCTION, meaning an invalid unit
4. A concrete / reinforced wall that affects the local media
Recommendations for solving the problem
1. Add a relay unit to increase the range and check that there are no units that
appear as
MALFUNCTION, that is, a valid unit, in the UNITS menu
2. Perform a procedure called Update Z-Wave network through the Z-WAVE
menu in the
Settings tab
3. The unit must be removed from the list - either by resetting or re-adding or
deleting, and the unit can be replaced by selecting REPLACE after pressing the
trash button
4. Position the antenna with respect to the frame plastic of the switch. The
antenna should exit the micro module
Question1. Is there a number on how many PIMA sensor alarms units can be connected
to the hub?
-
No, there is no limited number of how many devices can be installed.
Question 2. Is there a possibility to delete the devices once a unit is added?
-
Yes, there is possibility to delete the PIMA device. If you want to do this, for
any reason,
appear in the application where the Remove button should be clicked. After
clicking on this button, the sensor alarm will be removed.
click on the icon in the Units sub-menu. Another form will
37
Advertisement
Table of Contents
