Table of Contents
Advertisement
the scanning of the controller while clicking on the configuration button (usually 3 times
depending on the type of unit and its directory settings) while the camera is required to
press and hold the RESET UNIT button until the camera sound is heard. When the process
is completed, the name of the unit and the appropriate icon and management area of
that unit must be defined.
Once the unit is added, there is a possibility to see the unit's activity through in the Status
section. This can be very helpful when the device is not working properly for example and
the user can check the unit's activity.
The user can combine units from different systems, right now from the Z-Wave, KNX, or
IP work environments.
On the right side appears the table of the various units with the possibility to quickly
locate any unit using a filter – Filter Units or just filter the devices by name.
Also the user can see in which groups and scenarios a selected unit is active from the
sections Present in scenarios and Present in groups. Each unit can be attached to
different spaces or groups.
A button appears at the top to immediately add the unit to any group – Manage Unit
Groups. The importance of adding a unit to groups as can be seen below will greatly
contribute to the efficiency of constructing each scenario. Instead of marking each unit
individually, you can choose a total of units with a common feature that we define. For
example, all the lights in the bedroom and / or all the blinds in the central area.
10
Advertisement
Table of Contents
