Table of Contents
Advertisement
In the Advanced tab, the user can update and reset/heal the Z-Wave network. There is
also possibility to remove a unit, by entering the node ID in the Remove by note ID field.
A user with technician privileges can perform this action!
NETWORK RESET - This is a sweeping reset of all Z-WAVE units on the network, including
the disconnection of existing units from the controller only! Once we want to reuse
these units, a local RESET must be performed for each unit at the endpoint. This means
that even if NETWORK RESET is done and we want to go back to the previous step, you
can load an existing backup in the system and the endpoint units can communicate
immediately with the management unit.
NETWORK HEALING - This is the stage that takes place after all the end units have been
defined in the structure and after the functionality of each one has been tested. The
purpose of the procedure is to cure and optimize the communication between the
management unit and the end units. The duration of the procedure varies from apartment
to apartment and on average is about 15 minutes. While the procedure is being
performed, do not touch / change and / or physically and / or virtualize the endpoints for
the success and efficiency of the recorder.
23
Advertisement
Table of Contents
