Table of Contents
Advertisement
KNX System Setup
The KNX submenu is visible and available for editing only for users with technician/installer
privileges!
The Wanderful system supports an integrated connection or a KNX system connection
only or a Z-WAVE system connection only.
When connecting the KNX system, the connection can be activated in two ways:
•A direct connection in which the KNX IP address is required.
A direct connection can be required when some of home internet routers/switches block
the multicast messages inside LAN, and the best solution is direct connection.
•Connection by means of a multicast. The multicast connection type is the connection
when the KNX router listen/sends events to specific reserved IP address, additionally to
direct connections (if they exist).
We recommend that the standard installer use the direct connection setting and not allow
the system to find the IP-KNX unit on its own.
General Settings - Z-WAVE System Setup
The Z-Wave submenu is visible and available for editing only for users with
technician/installer privileges!
21
Advertisement
Table of Contents
