Alarm Operation Method In Analog Mode - Baofeng DM-5R User Manual

Alarm Operation Method in Analog Mode

Initiate an Alarm
Press and hold the "Side button 1 (Call)" to enter the alarm
mode, the red LEDturns on, the alarm LED flashes, and the local
alarm (alarm sound cycle at 5 seconds interval) and wireless
alarm sound are sent.
Exit Alarm
Alarm initiator can exit the alarm mode in the following ways:
● Press the [Call] button again.
● Turn off the unit.
● After the number of alarm cycles has been used, the radio will
automatically exit the emergency alarm mode.
Receive Alarm
Speaker outputs alarm sound (receives alarm sound 5 seconds
and stops 5 seconds).
Individual Operation
This feature is ideal for people who work alone. If you encounter
unexpected situations during individual operation, you can't
operate the radio in preset time. The radio will automatically send
alarm to your partner or control center for help.
1. Turn on individual operation
● Through writing frequency software, this function is turned
on when the radio is started.
● Press the preset [Individual Operation] shortcut to enable
this function.
2. If you do not operate the radio in the preset response time, the
radio will prompt before the response time is up (depending on
the dealer settings). At this point, you can end the prompt with a
valid physical operation (knob or button operation). When the
response time is up, the radio will automatically turn on the alarm
system of the current channel.
3. Turn off individual operation
● Turn this function off by writing-frequency software.
● Press the preset [Individual Operation] shortcut again to turn
off this function.
Note: If you do not turn off the individual operation function
before shutting down, the function is still active the next time you
turn on the radio.
Set Two-way Radio
You can set the radio as follows according to your own
preferences and actual needs to maximize the effectiveness.
Setting method: Enter "Settings ->Radio settings" menu, and
select the appropriate settings. You can also press and hold the
[MENU] button to enter the radio device.