Table of Contents
Advertisement
* button in the main interface to enter single call number, select
"Remote monitor", and press the [MENU] button to start;
"Remote monitor is successful" displays if it is successful, and
"Remote monitor failed" displays if fails. When the radio
detection is successful, you can monitor the background sound
and voice of the other party.
● Receive remote monitor:
After receiving the remote monitor command, it automatically
starts
transmitting
voice
background
sound,
and
transmission time is up.
Note: This function works only if the function is set and turned on
by writing-frequency software.
Radio activation
In digital mode, you can send an activation command to a
contact to resume normal use of the two-way radio.
● Initiate radio activation:
Select single call contact (enter "Menu -> Contacts -> Press [
/[
] to select single call contact ->Radio activation"), or press
the * button in the main interface to enter single call number,
select "Radio activation", and press the [MENU] button to start;
"Radio activations successful" displays if it is successful, and
"Radio activation failed" displays if fails.
● Receive radio activation:
After receiving the radio activation command, send activation
tone, re-shutdown and then boot. It can also be activated by
and
surrounding
environment
exits
automatically
when
writing frequency software.
Note:
This function works only if the function is set and turned on
by writing-frequency software.
Radio remote inhibit
In digital mode, you can send a remote inhibit command to a
contact, so that the radio can't be used normally.
● Initiate inhibit:
Select single call contact (enter "Menu -> Contacts -> Press [
the
/[
] to select single call contact ->Radio inhibit"), or press the *
button in the main interface to enter single call number, select
"Radio inhibit", and press the [MENU] button to start; "Radio
inhibit is successful" displays if it is successful, and "Radio inhibit
failed" displays if fails.
● Receive inhibit:
After receiving the radio inhibit command, send inhibit prompt
tone, and press the [PTT]button to display "Transmission failed
and inhibited". It can be activated by SMS writing frequency or
]
wake-up.
Note:
This function works only if the function is set and turned on
by writing-frequency software.
Emergency Alarm
In the event of an emergency, you can use this function to ask
your partners or control center for help. Emergency alarm has
the highest priority, and you can alarm regardless of whether the
radio is in the transmitter or receiver state.
]
Hide quick links:
Advertisement
Table of Contents
