Sub-Audio; View Radio Info - Baofeng DM-5R User Manual

OFF
OFF 1~10
1~10
Input Input 001~128
001~128
Input Input 001~128
001~128
OFF
Step: 1 (200ms) When the signal is
transmitted across the relay station and
retransmitted by it, in order to confirm
whether the relay station has retransmitted
the signal for this two-way radio, the delay
time of the relay station
transmitting shall be utilized to confirm that
the signal has been retransmitted. The
menu item is used to adjust the time of the
noise. If the noise isn't needed, please set it
as OFF
To save a channel, manually enter the
channel number to be saved. If the input
channel has a parameter, the word "CH"
appears at the top right of the screen, which
indicates that current channel has been
saved and continuing operation
overwrite it."--" indicates that empty channel
can be saved. When the range is
exceeded, it prompts "channel number is
illegal or mustn't be deleted"
To delete a channel, manually enter the
channel number to be deleted. If the input
channel has a parameter, the word "CH"
appears at the top right of the screen, which
indicates that current channel has been
saved and can be deleted. "--" indicates that
current channel is empty. When the range
is exceeded, it prompts "channel number is
illegal or mustn't be deleted"

Sub-audio

In analog channel, the speaker turns on only when the carrier
wave and sub audio match in order to avoid receiving irrelevant
call on the same frequency. Provide 51 sets of standard CTCSS
(analog sub audio) and also support non-standard sub audio.
Provides 108 sets of standard DCS (digital sub audio), and also
stopping
support non-standard DCS.
Sub-audio can be set via writing frequency software on the
reception or transmission CTCSS/DCS of analog channel or via
the "Settings ->Radio Settings -> Sub Audio" path of this product.
Enter "Sub audio codec", press the [A/B] button to select digital
sub audio, press [
the # button to switch between positive phase (N) and negative
phase (I).
● Press the[A/B]button to select "Sub audio codec", and press
[ ]/[ ] to select analog sub audio frequency.
will
● You can also enter the non-standard sub audio manually
through the keypad, press the [MENU]button to confirm, and
press the[EXIT]button to return.
● In "Sub audio codec "mode, press the * button to scan analog
sub audio.

View Radio Info

View the information about this product, including: own number
and radio model, serial number, CPS version, hardware version,
firmware version, DSP version, and programming time.
Own number menu path: Settings ->Radio Information
●
->Own Number.
]/[ ] to select digital sub audio code, press