Maytag ALY1680BD series Service Manual page 21

Installation Instructions
YPL1110AD*, CG11000AD*)
INSTALLATION
1. Cut opening as shown below (range can be suspended
from top flange; no other support is necessary.)
2. Range equipped with a 120 volt light in the oven will
require the installation of a 120V three prong grounded
receptacle directly behind the range (for correct
location see sketch below.) On range with BX cable
and marked for 12 volt DC power supply connect 12
volt DC power to the tagged wires.
3. Place range in opening and fasten in place. Six screw
holes that are provided are located at points AA and
BB. A minimum of four screws must be used to fasten
range. Recreational vehicle manufacturers may use
appropriate holes as found necessary to suit the
application. Use No. 8 flat head wood screws.
4. Make gas connections and check for leaks with non
corrosive leak detection fluid. Do not check for leaks
with open flame.
NOTE:Clearance spaces shall be framed
in or guarded to prevent storage space
within the clearance specified. Cabinet
enclosures shall be designed to prevent
drafts that will affect pilot stability.
©2005 Maytag Services
(All models except ALZ8590AD*, CPL1110AD*,
For RV Ranges
MODEL CUTOUT HT. PIPE LOC.
16 16 3/8
22 21 13/16
16023515
5. CAUTION: LIQUIFIED PETROLEUM (L.P.)/PROPANE
GAS SUPPLY LINE MUST HAVE A L.P. GAS
PRESSURE REGULATOR. INLET PRESSURE TO
THIS APPLIANCE SHOULD BE REDUCED TO A
MAXIMUM OF 14 INCHES WATER COLUMN (0.5
P.S.I.) INLET PRESSURES IN EXCESS OF 0.5 P.S.I.
CAN DAMAGE THE APPLIANCE PRESSURE
REGULATOR AND OTHER GAS COMPONENTS IN
THIS APPLIANCE AND CAN RESULT IN A GAS
LEAK.
WARNING:
Porcelain enamel is glass which has been
fused to metal. It is thoroughly inspected and will give
good service if carefully handled, but it is breakable and
cannot be guaranteed. Like all glass or porcelain articles,
we cannot replace enamel parts that are damaged after
delivery to carriers except at customer's expense.
1 7/8
2 5/8
A – 3