Table of Contents
Advertisement
Quick Links
INSTALLER:
LEAVE
THESE
INSTRUCTIONS
WITH THE APPLIANCE
INSTALLATION
MANUAL
'Gas 30-inch Wide Free-standingRange
PLEASE KEEP THIS MANUAL
FOR FUTURE
REFERENCE
THE MANUAL IS INTENDED TO ASSIST IN THE INITIAL INSTALLATION
AND ADJUSTMENTS
OF THE RANGE.
Only qualified
personnel
should
install or service this range.
Read "Safety
Instructions"
in the
Use & Care book before using
range.
Improper
installation,
adjustment,
alteration,
service,
maintenance
or
use of range can result in serious
injury or property
damage.
WARNING
• ALL RANGES CAN TIP AND
CAUSE INJURIES TO PERSONS.
• INSTALL
ANTI-TIP
DEVICES
PACKED WITH RANGE.
• FOLLOW ALL
INSTALLATION
INSTRUCTIONS.
CLEARANCE
DIMENSIONS
Range
may be installed
with zero inches clearance
adjacent
to (against)
combustible
construction
at the rear
and on the sides below the cooktop.
For complete
information
in regard to the installation of wall cabinets
above the range and clearances
to combustible
wall
above the cooking
top see the installation drawings.
For
SAFETY
CONSIDERATIONS
do not install a range
in any
combustible
cabinetry
which is not in accord
with the
installation
drawings.
* NOTE:
30 inch (76.2 cm) dimension
between
cooking
top and wall cabinet shown
on illustration
does not apply
to ranges
with an elevated
oven. The 36 inch (76.2 cm)
dimension
may be reduced
to not less than 24 inches
(61
cm) when the wall cabinets
in a domestic
home are
protected
with fireproof
materials
in accordance
with
American
National
Standards
- National
Fuel Gas Code or
in mobile homes
when they are protected
with fireproof
materials
in accordance
with the Federal
Standard
for
Mobile
Home Construction
and Safety.
To eliminate
the risk of burns or fire by reaching
over
heated
surface
units, cabinet
storage
space
located
above the surface
units should
be avoided.
If cabinet
storage
is to be provided,
the risk can be reduced
by
installing
a range hood that projects
horizontally
a
minimum
of 5 inches (13 cm) beyond
the bottom of the
cabinets.
CAUTION:
This
range
has been designed
in
accordance
with the requirements
of various safety
agencies
and complies
with the maximum
allowable
wood
cabinet
temperatures
of 194°F.
If this range
is installed with cabinets
that
have a lower working
temperature
than
194°F,
discoloration,
delamination
or melting
may occur.
8101 P624-60
(12-03-00)
Advertisement
Table of Contents
Related Manuals for Maytag MGR4452BDB - 4.5 GAS RANGES
Summary of Contents for Maytag MGR4452BDB - 4.5 GAS RANGES
- Page 1 INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE INSTALLATION MANUAL 'Gas 30-inch Wide Free-standingRange PLEASE KEEP THIS MANUAL FOR FUTURE REFERENCE THE MANUAL IS INTENDED TO ASSIST IN THE INITIAL INSTALLATION AND ADJUSTMENTS OF THE RANGE. CLEARANCE DIMENSIONS Range may be installed with zero inches clearance adjacent to (against)
-
Page 2: Installation Drawings
INSTALLATION DRAWINGS GAS LINE LOCATION NON-SELF CLEANING MODELS. -PROVIDE VOLT GROUNDED ELECTRICAL OUTLET THIS AREA. OUTLET MUST BE FLUSH. AREA 13"W X 9"H, CM L X 22.9 CM H) LOCATED 3/8" (23.8 ABOVE FLOOR, AND 1 ° (3.8 FROM RIGHT WALL. - Page 3 ANY COMBUSTIBLE SURFACE (76.2 CM)| 30" (76.2 CM). MAX. DEPTH MIN. "e_4_ CABINETS _(SEE NOTE ON FRONT PAGE) I ABOVE COOK CLEARANCE 0"(0 (45.7 cM) [ _BETWEEN ADJACENT • /_---.,. COMBUSTIBLE CONSTRUCTION BACK SIDES OF THE RANGE col, BELOW COOKING SURFACE.
-
Page 4: Anti-Tip Device Installation
ANTI-TIP DEVICE INSTALLATION INSTRUCTIONS NOTE: as shown in figure 2. (A nail or awl may be used if A risk of range tip over exists if the appliance not installed in accordance with the installation a drill is not available). Secure the ANTI-TIP bracket... -
Page 5: Electric Supply
CONNECTING THE RANGE ELECTRIC SUPPLY SUPPLY CONNECTION: (See figure 4) The appliance, when installed, must be electrically A QUALIFIED SERVICEMAN OR GAS APPLIANCE grounded in accordance with local codes or, in the INSTALLER MUST MAKE THE GAS SUPPLY absence of local codes, with the National Electrical Code,... - Page 6 Apply a non-corrosive leak detection fluid to all joints and fittings in the gas connection between the supply line shut-off valve and the range. Include gas fittings and joints in the range if connections were disturbed during installation. Check for leaks! Bubbles appearing around fittings...
- Page 7 RANGE ADJUSTMENTS Top Section - Gas Top Pilot Adjustment Top Burner Adjustment All Top Burner Valves: The approximate height of the (See figure 6) flame at the high or fu,-on position is shown below. Purge all air from supply system by turning on one top Adjust...
- Page 8 Air Shutter - Oven Burner Removing Sealed Burner For Adjustment Service: The approximate length of the flame of oven burner Mark ignitor location relative to main top with pencil. This a 1/2 inch distinct inner blue flame, figure 8. mark on the main top is used as a reference point when replacing the burner assembly...
-
Page 9: Gas Conversion
GAS CONVERSION TO REPLACE WARMING DRAWER: To access the regulator from front of range, remove the storage drawer or warming drawer. a. Pull the bearing glides to the front of the chassis glide. (See picture below). To remove storage drawer: Pull out to the first stop position. -
Page 10: How To Remove
HOW TO REMOVE RANGE FOR SERVICING servicer MUST follow installation instructions Follow these procedures remove appliance servicing: provided with the gas appliance connector and the warning label attached to the connector. 1. Shut off gas supply to appliance. 6. To prevent range from accidentally tipping, range must 2.
Need help?
Do you have a question about the MGR4452BDB - 4.5 GAS RANGES and is the answer not in the manual?
Questions and answers