Table of Contents
Advertisement
Lighting Pilot Burner
Lighting Pilots
1. Purge system of air by holding a match or lighter next to front surface burner and turning burner control
knob to "LO." When burner ignites, turn burner control knob back to "OFF."
2. OVEN PILOT: With the thermostat in the "OFF" position, hold a match or lighter near the oven pilot port
located near the rear of the oven burner. Remove match or lighter once pilot ignites.
3. SURFACE PILOTS: Hold a match or lighter near the two (2) top surface pilot ports. Remove match or
lighter once pilot ignites.
Adjusting Top Surface Pilot and Burner Flames
1. Top surface pilot flame should be even with top of flash tube. Adjust flame height using pilot adjustment
screw "A" (see graphic below).
2. Once proper pilot flame height is achieved, ignite burner and adjust burner flame.
3. Adjust burner air shutter to the widest opening that will not cause the flame to lift or blow off the burner
when cold (see graphic below).
C – 4
(Models CG11000AD*, CPL1110AD*, YPL1110AD*)
3/4 FLAME
AIR
SHUTTER
ORIFICE
HOOD
16023515
©2005 Maytag Services
Hide quick links:
Advertisement
Table of Contents
